BlackBerry 9800/ 9810 Torch disassembly instructions
We’ll help you to take apart the BlackBerry 9800/9810 Torch smartphone — use this instruction if you want to replace some parts for repair. Note, the process for 9800 and 9810 models are the same, but pictures made from 9800.
Note! Only you are responsible for the process and result. This device is very hard to disassemble. Go to service center if you are not sure.
For taking BlackBerry 9800/9810 apart, you will need these tools:
- T6 screwdriver
- T4 screwdriver
- T3 screwdriver
- T2 screwdriver
- Plastic pry tools
BlackBerry 9800/9810 Torch disassembly instructions
BlackBerry 9800/9810 Torch is a beautiful smarthpone. We should help it to be recovered in case of failure ;)
Take the battery cover off.
Screwdriver T6 will help you with this part, turn off four screws.
Take the pry tool and gently pull the bottom part of plastic bezel.
Now you can take off the bezel.
Under the top part of the bezel are two more T6 screws.
Take off the middle part of the BlackBerry 9800/9810 Torch housing now.
Here we are.
Pry off the board PCB connector.
Pry off the keypad PCB connector.
Pry off the LCD connector.
Take the motherboard in you hands, but don't be hurry.
There is another connector from other side of the motherboard.
Take off the antenna.
There are three T4 screws under the sticker from one side..
..And three more form other side.
Disconnect the LCD assembly now. Be careful with the connector.
Intermediate stage.
If you need to replace the keypad, do the pry work with its holder.
It is not so hard so.
Need to disassemble the LCD part? It is very responsible work. First these two T4 screws and two T3 screws.
You got the U-holder there.
Here are two more T3 screws, in the middle of this part.
Now we can pry the top of the touchscreen.
And continue to other sides.
Under the touchscreen is two small T2 screws.
Next pry off the connector of the LCD.
Yet another connector..
And the trackpad.
Take the trackpad off.
Take off functional buttons part on the other side.
Now it's time to separate the slider.
You'll see such a picture of BlackBerry 9800/9810.
Continue to touchscreen. Pry of this sticker.
Pry the connector of the touchscreen.
Here we are.
You can disconnect the speaker.
Now take off the touchscreen carefully.
We are almost done.
What else? You can pry the functional keypad PCB (as pictured). But we do not recommend to proceed with the LCD (is is glued!).
If you need replacement parts to repair your BlackBerry 9800/9810 Torch, go to InfoResheniya’s shop.